1. Install flow limiter in motor inlet. (suggested)
2. Shut off sprayer boom and agitation valves. Install pressure gauge between pump and shut off valve.
3. Close motor needle valve; loosen jam nut, screw needle valve clockwise until seated, and lock nut.
4. Adjust tractor flow control to minimum flow setting (turtle).
5. Move hydraulic lever to "Lower/Retract position to start pump.
6. Adjust tractor flow control until sprayer shut-off pressure is below maximum shown in table.

If the flow limiter stops oil flow to the motor:

6a) Move hydraulic lever to "Float" or "Neutral" to remove oil pressure from the flow limiter.
6b) Adjust tractor flow control to a lower flow position.
6c) Repeat steps 5 and 6.

7. Open the sprayer agitation valve to get desired spraying pressure.